Sealants & Adhesives
Full range of Sealants & Adhesives for Siniat Systems.
-
Can I use Siniat Intumescent Acoustic Sealant instead of the taping and jointing process, when boards don't need decoration?
Siniat have not tested internal drywall systems with the plasterboard joints treated with our intumescent sealant . As such, for Siniat to warrant system performance, the board joints must have the tape and joint process or a reinforced joint skim finish applied. Details of the tape and joint process can be found in the Siniat Drywall Manual . Fo
-
Are Siniat sealants compatible with cPVC Pipes?
Sealants and cPVC pipework compatibility Siniat Intumescent Acoustic Sealant is not suitable for use with cPVC pipework and must not be used for this application. Incorrect product selection in these situations can lead to compatibility issues and may compromise the performance and durability of both the pipework and the fire‑stopping system. Please
-
What is the coverage of your Siniat Intumescent Acoustic Sealant?
The Siniat Intumescent Acoustic Sealant is supplied in 0.6L foil rolls which will provide 17 linear metres based on a 6mm thick bead.
-
What is the coverage of your Siniat branded sealants?
Understanding sealant coverage is essential when planning works, ordering materials, and ensuring continuity of fire and acoustic performance across wall and floor constructions. Below is a guide to the typical coverage and key characteristics of Siniat branded sealants based on Siniat product information and technical data. Siniat Fire Rated Silico
-
What is the application temperature range of your Fire Rated Silicone Sealant?
The Fire Rated Silicone Sealant should be installed when the ambient temperature is between 5 and 35 degrees. It is recommended to allow the product to acclimatise if stored in a cold area first.
-
What depth of Promat HPEx Sealant is required around cPVC sprinkler Pipes to Non-Fire Rated partitions?
For Non-Fire rated partitions, the depth of Promat HPEx sealant is as per the depth of plasterboard on each side of the partition. This will be a minimum of 12.5mm or 15mm for single sided partitions as this is only creating an acoustic seal in these locations.
-
Can you use Siniat Universal Bonding Compound against a plastered background?
Siniat Universal Bonding Compound is not recommended to be used on a plaster background (painted or unfinished). Instead it is recommended to use the Siniat Shallow Wall Channel mechanically fixed through the plaster to the substrate behind with suitable fixings assuming the surface is plumb and true. The Shallow Wall Channel is 15mm deep which wil
-
Are there products in the Siniat range to improve mechanical key on smooth surfaces and prime high or low suction backgrounds?
No, Siniat do not have products for these applications. The substrate must be clean of all contaminants and dust free. Very low suction backgrounds may require mechanical fixing system. High suction backgrounds will require a 3rd party PVAC bonding agent. Siniat do not recommend specific brands for this. General information on the Siniat Direct Bond
-
What guidance is there for fire stopping pipe penetrations?
Regulatory context and scope To ensure pipe penetrations through Siniat systems are adequately fire‑stopped, all solutions must align with the project fire strategy and the requirements of Approved Document B (ADB), Section 9 – Protection of openings and fire‑stopping. Any approach used must be supported by tested and classified fire‑stopping soluti
-
Could I install cable penetration through head track?
It is recommended cable penetrations avoid framing components and penetrate board only. The hole should be as tight as possible with Siniat Intumescent Acoustic Sealant to seal the hole to the cable. For partitions without deflection heads the cable should be installed with enough slack to allow it too drop below the head track and pass through boar